Used OMC Parts
There are various marine companies having worldwide reputation in selling and repairing in used OMC parts. Various used OMC parts are available in the market, if one can not afford to purchase the new OMC part, old and repaired OMC part are the best option. These parts are comparatively cheap and are in very good conditions and are easily affordable. Some of the used OMC parts available in the market are as given below.
The OMC propellers are generally stainless steel make and available sometimes with three blades and generally most of the OMC requires four blades. These are the heart of any vehicle and are available in various HP capacities. The propeller rating and displacement or fuel system are also important for a specific purpose motorboat. These are the important OMC parts and every used propeller must be selected carefully on the basis of actual requirement. The propellers may be either 2 strokes or 4 strokes. The old propellers are available from a very short duration use to large use and accordingly the cost comes down.
Used Water Pumps:
Raw water pumps or circulating water pumps are used for cooling outboard engines by continuously circulating water. These pumps are supplied with full instructions and can be replaced easily. Fuel pumps are small nozzles through which fuel, which is generally diesel, is injected to the engine. Although the repaired pumps are rarely used, but even then the repaired water and fuel pumps are cheap and can be used for some duration.
Used Fuel and Lube Pumps:
Fuel system consists of various parts including pumps, hoses, and fuel tanks; pump kits, carburetor kits, filters, oil injection assemblies, gasket etc. Used system available in the markets may include some repaired parts along with some new parts such as filters and carburetors are always replaced.
Used electrical assemblies:
These are the wirings, bulbs etc and can be used if these are not too old. Bulbs and wirings should be checked before purchasing and the quality should be ensured.
Used Oil Coolers:
Used oil coolers may be very cost effective and should be checked before purchasing.
These are the cylindrical coolers used for cooling oil and these are available in varying sizes from 5” * 1” to 12” * 1.25” and sometimes two cylinders attached together are provided as dual coolers.
Used Exhaust Manual:
These OMC parts are used for removing combustion gases from engine through exhaust manifold. These are attached to the exhaust system. We should ensure that there is no leakage from the exhaust manual. This used exhaust manual should also be checked for any cracks in the system. Cracks and leakage will cause pollution to the water, which should be avoided.
Used OMC Upper and Lower Gear Cases:
After market boat parts includes the upper and lower gear cases. These parts will be fully repaired before offering for sale. These parts will also be checked before being supplied to the users, as these are important parts required for smooth running of OMC.
Used electronic kit:
Electronic kits are useful for maintaining and increasing HP at a continuous pace or as desired by the user. This increases the fuel economy of the OMC boat and therefore is useful for the user. This electronic device is safe and easy to install. Electronic kit increases the life of spark plug and old electronic kits available in the market are very cost effective and should be preferred for achieving cost effectiveness.
About the Author: Trish is the author for http://www.sterndrive.info - Get more information on Used OMC Parts.