Article Keyword Videos to Watch
Click on the image to start the video.
Images - Links - Articles
OMC Stern drive Thermostat Kit
The OMC outboards are water vehicle and are available in two stroke and four-stroke category. The propeller system provided with these omc outboards is designed to give you that the best performance for all the applications. For a special application, you may select a specific propeller. You need various accessories to maintain and run stern drive smoothly and stern drive thermostat kit is one of them.
Horsepower requirement of Motor OMC Outboards:
By US law (US coast guard regulation) a boat up to 20 feet in length should carry a plate mentioning the maximum horsepower rating of the vehicle. These motor OMC out boards are available in different horsepower ratings. Outboards are available in two stroke and four stroke engines. Depending upon the engine rating, the other specifications including horsepower of the vehicle are provided in the brochure. Most of outboards manufacturers power rate the engine in accordance with the NMMA procedure using international council on marine industry associates (ICOMIA) standards 28/83.
OMC Stern Drive Thermostat Kits:
Thermostat kit is one of the essential parts of the OMC stern drive and proper repair or replacement is required whenever a fault is noticed in any of the parts of the kits. These thermostat kits are being supplied by various manufacturers and usually contain gaskets, O- ring, thermostat and set for 160 degree.
The thermostat kit suitable for one OMC stern drive may not necessarily fit for another stern drive. Therefore it is necessary to look for a suitable stern drive thermostat kit and ensure the suitability of the thermostat kit being supplied to you is meant for the OMC stern drive you have.
Other accessories required for OMC stern drive:
Some of the other accessories required for smooth running of the OMC stern drives includes fuel filter, carburetor kits, stern water drive pump, exhaust manifold, impeller thermostat, engine water pump, fuel pump, drive shaft, pinion bearing, drive stern anode, pinion gear, bearings, upper gears, shims, bearing retainers, OMC stern drive lower unit tools etc.
Safety is one of the biggest aspects of these Motor OMC outboards. Although every motor OMC outboard manufacturers give the utmost priority to the safety, a few backfire problems has been reported and these backfires increases the risk of damaging engine collector assembly. In case if a break in collector assembly happens, it may cause serious injuries to the persons. For avoiding these backfires, a proper voltage electronic and adequate better battery cables should be maintained.
Proper maintenance of Motor OMC Outboards:
Maintenance schedule should be followed at regular interval as provided in manual. The recommended grade of lubricants should be used always and in no case the used lube oil should be drained in water or earth.
Regular check up of Motor OMC outboards should be carried out to see
• The adequate electric wiring is maintained.
• The water level in battery or efficiency of battery is maintained.
• He carburetor is clean and fuel pump is operating properly.
• Proper quality of fuel is being used.
• Lubricant level and lubricant quality is maintained and lubricants are replaced as and when required.
• Engine tuning is proper and maintained.
• Gears are in good operating conditions.
• Brakes are in good operating conditions.
About the Author: Trish is the author for http://www.sterndrive.info - Get more information on OMC Stern Drive Thermostat Kits.